![]() ![]() The most common symptoms of a bad camshaft position sensor are a hard-to-start engine or a check engine light on your dashboard. Once you are done, get inside your car, start the engine and then take your car around the block to test its' performance.Will a bad camshaft sensor throw a code? Symptoms Of A Bad Camshaft Position Sensor Check if the actuator is centered at the gap repeat if not aligned. Install the new one – precisely marking it exactly where the original synchronizer is marked. If so, stop and retrieve it from the oil pan and put it back in place then continue with pulling out of the synchronizer. Warning: the oil pump drive must not be disconnected, if it does you will hear a metallic sound while pulling up the synchronizer. When inserting the new one later, it should go on in the opposite direction while aligning the marks. Pull out the synchronizer (which rotates) at an angle to clear it from the lower intake manifold. ![]() Mark the synchronizer and engine block for alignment reference. Remove the bolt of synchronizer clamp using a 10mm socket. ![]() If the actuator is at the opposite gap, adjust the crank and make sure that the crankshaft pointer and pulley marks are aligned. Its gap must be near the top of the synchronizer. Step 5 – Remove the Existing SynchronizerĬheck the metal finger on top of the synchronizer (the actuator). Remove the screws and the camshaft sensor by pulling it straight up. Squeeze the camshaft sensor connector from beneath and pull. Take note which way the camshaft sensor points to – this should be carefully noted to ensure the correct orientation when the new one is installed. For example, with markings 1 1 and 1 0, the number “1” is the correct position. Adjust the crank shaft so the hash mark is pointing at the first digit of the two numbers found on the markings. Find the crankshaft pulley and the timing mark (two digits) on it, as well as the pointer at the front side of the engine. Turn the crank shaft using a 19mm socket with a short extension from underneath the truck. Step 3 – Set Crank Shaft at Top Dead Center Uninstall the air intake tube and the air filter then take out the upper intake manifold. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |